ball bearing skateboard are not as precise as those of the yo-yo, because there are eight bearings and four middle locks on a board. It is best to replace all eight bearings. This is necessary no matter which shaft explodes first.
Introduction
ball bearing skateboard are not as precise as those of the yo-yo, because there are eight bearings and four middle locks on a board. It is best to replace all eight bearings. This is necessary no matter which shaft explodes first.
Bearing cleaning
The cleaning of the ball bearing skateboard is very simple. Take the bearing off the board, wipe off the oil and dirt on the bearing with a paper towel, and wipe off the inner wall of the wheel. Changing the wheels on the left, right, front and rear is good for the smoothness of the bearing. It is cleaned about once a week. The high temperature generated by the rotation of the bearing when using the plate will close the rubber of the wheel to the bearing wall, causing inconvenience when changing the wheel or bearing. Therefore, remove the bearing and install the wheel frequently. To avoid trouble, the bearings can be cleaned at the same time.
Bearing oiling
Remember to apply oil after cleaning. The range of oil is very wide. Cooking oil is fine. However, some people say that the bearings you buy are soaked in gasoline for a week. This is a waste of gasoline. It does not matter if the ball bearing skateboard is oiled. The bearing that has just been bought has lubricating oil to store the oil to prevent the bearing from rusting. When the plate is used, the oil can be sent out of the bearing. Oil, these oils do not play a lubricating effect, just like the measuring cylinder can not be heated only to measure the role of liquid, only to prevent rust, but the plate bearings that are often used are difficult to rust.
Bearing rust
The ball bearing skateboard will rust when it touches water. If you want to continue sliding after passing through the water, the moisture of the wheel will evaporate very quickly, and it will evaporate after about 10 meters of sliding.
Welcome to contact me to get the price of ball bearing skateboard!
Contact: Ellen
Email: [email protected]
Skype: +8618668909563
MP/Whatsapp: +8618668909563
Wechat:18668909563
Double row angular contact ball bearing installation is more complex than deep groove ball bearin...
Failure reason of micro miniature bearing About 40% of the failure of micro miniature bearings i...
Novice Mistakes 1: Do not consider the characteristics of your own actions, blindly choose Althou...
When assembling cnc machine bearings, the Venus machine tool must be preloaded, so that the origi...
Performance characteristics of stainless steel self-aligning ball bearing Self-aligning ball bear...
The long board has a strong sense of operation and is quick to get started. The longboard is a mu...
The tapered thrust bearing with cage is a split design so that the two washers as well as the rol...
Disassembly of the tapered needle bearing: When the bearing is to be used continuously after it i...
TEL: +86 183-6303-1398
E-mail: [email protected]
E-mail: [email protected]
Whatsapp: +8618668909563
Whatsapp: +8618363031398
ADD: Room E3-1203, Mingquanchunxiao, Dikou Road, Tianqiao District, Jinan City Shandong Province, China.