search
banner

How much do you know about bearings skateboard?

2,565 Published by Oct 15,2020

bearings skateboard are not as precise as those of the yo-yo, because there are eight bearings and four middle locks on a board. It is best to replace all eight of the bearings. This is necessary no matter which shaft explodes first.

skateboard wheels longboard

bearings skateboard cleaning
The cleaning of the bearings skateboard is very simple. Remove the bearing from the board, wipe off the oil and stains on the bearing with a paper towel, and wipe off the inner wall of the wheel. Changing the wheels on the left, right, front and rear is good for the smoothness of the bearing. It is cleaned about once a week. The high temperature generated by the rotation of the bearing when using the plate will close the rubber of the wheel to the bearing wall, causing inconvenience when changing the wheel or bearing. Therefore, the bearing should be removed and the wheel is often installed. To avoid trouble, the bearings can be cleaned at the same time.

skateboard wheels longboard high speed
bearings skateboard oil
Remember to apply oil after cleaning. The range of oil is very wide. Cooking oil is fine. However, some people say that the bearings you buy are soaked in gasoline for a week. This is a waste of gasoline. If you buy them, you need to clean them after a week. It does not matter if the bearing is oiled. The bearing that has just been bought has lubricating oil to store the oil to prevent the bearing from rusting. When the plate is used, the oil can be sent out of the bearing. When cleaning, remove the oil used for the first time. Oil, these oils do not play a lubricating effect, just like the measuring cylinder can not be heated only to measure the role of liquid, only to prevent rust, but often used plate bearings are difficult to rust.

skateboard bearings ceramic
Bearing rust
The bearings skateboard will rust when it touches water. If you want to continue sliding after passing through the water, the moisture of the wheel will evaporate very quickly, and it will be evaporated after about 10 meters of sliding.

Welcome to contact me to get the price of bearings skateboard!

Contact: Ellen
Email: [email protected]
Skype: +8618668909563
MP/Whatsapp: +8618668909563
Wechat:18668909563

 

How to install the double row angular contact ball bearing?

Double row angular contact ball bearing installation is more complex than deep groove ball bearin...

Do you like ? 4,790

Read more

The cause of micro miniature bearing failure and the solution to overheating of temperature.

Failure reason of micro miniature bearing About 40% of the failure of micro miniature bearings i...

Do you like ? 1,684

Read more

Six Mistakes in the Replacement of skate shoes ceramic bearing by Novices

Novice Mistakes 1: Do not consider the characteristics of your own actions, blindly choose Althou...

Do you like ? 1,609

Read more

CNC machine bearings common quality problems and main causes.

When assembling cnc machine bearings, the Venus machine tool must be preloaded, so that the origi...

Do you like ? 2,221

Read more

the performance and feature of stainless steel self-aligning ball bearing

Performance characteristics of stainless steel self-aligning ball bearing Self-aligning ball bear...

Do you like ? 1,694

Read more

How to choose the suitable longboard skateboard wheels?

The long board has a strong sense of operation and is quick to get started. The longboard is a mu...

Do you like ? 1,587

Read more

What’s the design and installation of tapered thrust bearing?

The tapered thrust bearing with cage is a split design so that the two washers as well as the rol...

Do you like ? 1,981

Read more

the disassembly, installation and operating environment of tapered needle bearing

Disassembly of the tapered needle bearing: When the bearing is to be used continuously after it i...

Do you like ? 1,437

Read more