search
banner

How to install flanged cam follower bearing?

3,495 Published by Nov 03,2021

1. After making the center line of the mounting hole and the movement direction of the flanged cam follower bearing at right angles, the side of the mounting hole should be aligned correctly according to the / size in the size table and then fixed with a nut. (Refer to Figure 1) When installing, do not directly hit the flange of the cam follower bearing with a hammer, otherwise it may cause poor rotation or breakage.

flanged cam follower supplier

 

2. The mark on the side of the rod end flange indicates the oil hole position on the track surface S. When installing, be careful not to install the oil hole in the load area. The oil hole located in the load domain will shorten the service life of the flanged cam follower bearing. (Refer to Figure 2) The vertical hole in the center of the rod end is used for refueling or stopping.

flanged cam follower factory

 

3. When tightening the nut, it should not exceed the maximum tightening torque range shown in the dimension table. Excessive tightening torque may sometimes cause the threaded part of the rod end to break. In addition, if it is used under some working conditions that may loosen the nut, use a lock nut, spring washer or special lock nut, etc.

flanged cam follower producer

4. Eccentric flanged cam follower bearing with eccentric sleeve. The position S of the outer ring of the bearing can be adjusted by rotating it with the screwdriver on the top of the rod end or the hexagonal hole. The rod end can be fixed with a spring washer, etc. and screwed with a screw nut. When tightening the nut, the maximum tightening torque range shown in the dimension table should not be exceeded.

flanged cam follower manufacturer

 

When bearing an impact load and need to correctly maintain the eccentric adjustment, as shown in Figure 3, it is recommended to pass through the shaft hole to make a hole for the rod or eccentric shaft sleeve, and fix it with a positioning pin. However, the flanged cam follower bearing rod end with a rod end diameter of 8mm or less (eccentric bushing diameter 11mm) is quenched and hardened.

Welcome to contact me to get the price of flanged cam follower bearing!

Contact: Miya
Email: [email protected]
Skype: [email protected]
MP/Whatsapp: (86)18363031398
Wechat:18363031368

 

How to install the double row angular contact ball bearing?

Double row angular contact ball bearing installation is more complex than deep groove ball bearin...

Do you like ? 4,790

Read more

The cause of micro miniature bearing failure and the solution to overheating of temperature.

Failure reason of micro miniature bearing About 40% of the failure of micro miniature bearings i...

Do you like ? 1,684

Read more

Six Mistakes in the Replacement of skate shoes ceramic bearing by Novices

Novice Mistakes 1: Do not consider the characteristics of your own actions, blindly choose Althou...

Do you like ? 1,609

Read more

CNC machine bearings common quality problems and main causes.

When assembling cnc machine bearings, the Venus machine tool must be preloaded, so that the origi...

Do you like ? 2,221

Read more

the performance and feature of stainless steel self-aligning ball bearing

Performance characteristics of stainless steel self-aligning ball bearing Self-aligning ball bear...

Do you like ? 1,694

Read more

How to choose the suitable longboard skateboard wheels?

The long board has a strong sense of operation and is quick to get started. The longboard is a mu...

Do you like ? 1,587

Read more

What’s the design and installation of tapered thrust bearing?

The tapered thrust bearing with cage is a split design so that the two washers as well as the rol...

Do you like ? 1,981

Read more

the disassembly, installation and operating environment of tapered needle bearing

Disassembly of the tapered needle bearing: When the bearing is to be used continuously after it i...

Do you like ? 1,437

Read more