How to maintain forklift bearing?

Product lubrication
Forklift bearing lubrication, first open the cover and observe the wear of the release bearing. If it is confirmed that the bearing is not damaged or the wear does not exceed the limit, remove the clutch pedal, adjust the ejector rod, and return the release bearing and its seat to the final position. Use a sharp-nosed grease gun to add grease to the hole of the bearing seat until the bearing overflows with oil, then turn the bearing a little, add oil again, and repeat the above work until a little butter overflows around the bearing, then rotate the forklift bearing and observe the oil If there is resistance to the rotation of the bearing, it proves that the bearing has been filled with butter. Then remove a small amount of butter overflowing from the release bearing seat, and readjust the release bearing position.

Notes
1. Keep the forklift bearing and its surrounding environment clean
Even smiling dust that is invisible to the naked eye enters the forklift bearing, it will increase the wear, vibration and noise of the forklift bearing.
2. Be careful when using and installing forklift bearing
Strong punching is not allowed, the forklift bearing is not allowed to be hit directly with a hammer, and the pressure is not allowed to be transmitted through the rolling elements.
3. Use appropriate and accurate installation tools
Use special tools whenever possible, and try to avoid things like cloth and short fibers.
4. to prevent the corrosion of the forklift bearing

When taking the forklift bearing directly by hand, it is necessary to fully wash off the sweat on the hands, and apply high-quality mineral oil before operation, especially in the rainy season and summer, pay special attention to rust prevention.
However, under certain special operating conditions, forklift bearings can achieve a longer life than traditional calculations, especially under light loads. These special operating conditions are when the rolling surfaces (tracks and rolling elements) are effectively separated by a lubricating film and limit contamination that may cause surface damage.

Contact: Miya
Email: [email protected]
Skype: +8618363031398
MP/Whatsapp: +8618363031398
Wechat: 18363031398