Install the bearing should be carried out in a dry, dust-free area, and should be far away from equipment can produce metal debris and dust. When must be installed in a complex environment, should be to minimize pollution.
Cylindrical bearing installation
Cold installationCooperate with not too tight little roller bearing block installation, can be through a sleeve (figure 5, figure 6), and by hammering method, tapping the sleeve bearing is put into place. Should as far as possible even when knock the effect on the bearing ring, in order to prevent the bearing tilt or skewed.
Most of the bearing pressure into the method for installation. If you would have a bearing inner and outer ring loaded on the shaft and roller bearing block at the same time, must ensure that the same pressure effect on the outer ring, at the same time, and must be installed with the tool interface on the same plane.
Heat installation
Normally, for larger roller bearing block installation, not by heating the bearing or bearing is impossible, because with the increase of the size, the greater the force needed for the installation. Heat installation needed between the bearing ring and the shaft or housing, the interference temperature mainly depends on the quantity and the diameter of the bearing fit place. Open type roller bearing block heating temperature shall not exceed 120 ℃, bearings with seals and dust cover is not recommended be heated to above 80 ℃ (shall ensure that the temperature does not exceed seals and grease allowed temperature)Bearing heating, uniform heating, never can have local overheating.
Welcome to contact me to get the price of roller bearing block!
Contact: Ellen
Email: [email protected]
Skype: +8618668909563
MP/Whatsapp: +8618668909563
Wechat:18668909563
Double row angular contact ball bearing installation is more complex than deep groove ball bearin...
Failure reason of micro miniature bearing About 40% of the failure of micro miniature bearings i...
Novice Mistakes 1: Do not consider the characteristics of your own actions, blindly choose Althou...
When assembling cnc machine bearings, the Venus machine tool must be preloaded, so that the origi...
Performance characteristics of stainless steel self-aligning ball bearing Self-aligning ball bear...
The long board has a strong sense of operation and is quick to get started. The longboard is a mu...
The tapered thrust bearing with cage is a split design so that the two washers as well as the rol...
Disassembly of the tapered needle bearing: When the bearing is to be used continuously after it i...
TEL: +86 183-6303-1398
E-mail: [email protected]
E-mail: [email protected]
Whatsapp: +8618668909563
Whatsapp: +8618363031398
ADD: Room E3-1203, Mingquanchunxiao, Dikou Road, Tianqiao District, Jinan City Shandong Province, China.